This is a Grado headband built with high quality artificial leather, high density foam padding, stainless steel + aluminum brackets and lockers (much stronger than original Grado locker in plastic). It is designed to to upgrade low quality headband in most low-end, plastic Grado headphones. 2 color options in black and brown are available.
See an example below where the Grado M1 headband is replaced with the news one. Scroll down for the DIY tutorial to upgrade your Grado headphones, and following are compatible Grado models we’ve verified with:
- Grado SR80, SR80e
- Grado SR225
- Grado M1
- Grado SR60, SR60e
We include everything you need (expect the headband) to upgrade your Grado headbands.
- 1 X headband, built with high quality artificial leather, high density foam padding and stainless steel bracket inside, in black or brown
- 2 X headphone cup lockers, aluminum, in black or rose gold
- 2 X U shape headphone cup surrounding, aluminum, in black or rose gold
- Accessories for installation
- Ear Pads (optional S or G Cushion)
DIY course to upgrade your cheaper Grado Headphones (SR60e as an example)
Here is a very detailed YouTube video on how to do it with SR60e. Note the video is with other customized wood cups but most contents are applicable with this kit.
The headband in brown or black
The U bracket – 60mm diameter
Ear pads (sponge cushions)
We offer 2 types of cushions: type G or type S. Type G is a solid circle and type S is a hollow circle as illustrated below.
Here is a step by step tutorial to replace original Grado headband.
Step 1, take off the original headband and earpads
Notice there are 2 tiny holes left on each side of the cup.
Step 2, get the bracket ready
Position the bracket with the cup and match its holes with the one on the cup, then insert the 2 screws.
Do it on both side, and you will get this. Note sometime the hole on the cup may be blocked, then you will need to drill it open to 3mm, and let the screw in.
Step 3, glue the screws to the cup
This is the most tricky step and here is the tips:
- It it to glue the screw to the cup, not to the bracket. Don’t let the glue stick the screw and the bracket together!
- The glue can be any instant dry model applicable to plastic and steel. We use Ergo 5910/5920 which are easily accessible from any online store. A/B glue also works very well.
- A little bit glue shall be enough. You can use a toothpick and take a tiny little bit drop of glue and get it in the gap between the screw and the cup. See the pic blow.
- Wait >30min until the the glue fully dries
Step 4, do it for both side, put on earpads and done!
As you can see, not difficult at all!